autotelic.build(720) 287-7958

DESIGN · BUILD · AUTOMATE

CENTENNIAL SERVICES

Plumbing in Centennial

Licensed plumbing services for Centennial and Arapahoe County. Reliable plumbing systems.

What Centennial requires

Code reference: In Centennial, Colorado, building permits for residential remodel work are governed by the 2021 International Residential Code (IRC) Section R105 (adopted via Centennial Municipal Code Chapter 18 – Building Regulations, per Ordinance 2023-O-06 and related adoptions of the 2021 I-Codes). §R105

See full local requirements ↓
  • Full Design Lifecycle
  • Construction & Tenant Finish
  • Smart Home · A/V · Edge Compute
Plumbing

Reliable plumbing systems

FREE PLANNING TOOLS

Both tools are free and take a couple of minutes — start in either one.

BOOK ONLINE

Book it now

On-page checkout — pick a time and pay in under a minute, without leaving this page.

Local Service

Plumbing Services in Centennial, Colorado

Autotelic provides professional plumbing services throughout Centennial and the surrounding Arapahoe County area. Complete plumbing services including rough-in, fixture installation, water heaters, and repiping for homes and commercial spaces. Whether you're in Centennial (south Denver metro) or nearby communities, our team delivers quality workmanship backed by Colorado licensing and full insurance coverage.

Permits & Licensing

Permits in Centennial

Centennial building permits, inspections, and contractor license approvals are handled by the city's Building Division. Permits and contractor licenses must be applied for online through the city's Self-Service Portal, and we handle that process as part of every project. Authority: City of Centennial — Building Division.

Permit Thresholds

Centennial permit thresholds

Code reference
In Centennial, Colorado, building permits for residential remodel work are governed by the 2021 International Residential Code (IRC) Section R105 (adopted via Centennial Municipal Code Chapter 18 – Building Regulations, per Ordinance 2023-O-06 and related adoptions of the 2021 I-Codes).§R105
Code reference
Typically exempt work (aligning with IRC R105.2 exemptions, with local application) includes:
Code reference
One-story detached accessory structures (e.g., sheds) ≤200 sq ft.
Code reference
Fences ≤7 ft high; retaining walls ≤4 ft high (measured from bottom of footing).
Code reference
Prefabricated swimming pools <24 inches deep.
Code reference
Window awnings projecting ≤54 inches.
Code reference
Decks ≤200 sq ft, ≤30 inches above grade, and not attached to the dwelling.
Use tax (not collapsed into a single rate)
City of Centennial Use Tax of 2.5% applied to the actual cost of materials, plus Arapahoe County Use Tax of 0.25% applied to the actual cost of materials.

Codes are amended regularly — verify current requirements with City of Centennial — Building Division.

Energy Code

Centennial energy code quick facts

Code reference
Centennial, Colorado, has adopted the 2018 IECC (with the 2021 I-Codes package) as its energy code, with no mention of Denver-specific overlays such as the Denver Green Code or Energize Denver.
Code reference
This is enforced by the City’s Building Division under Ordinance No. 2023-O-06 (adopting the referenced codes by reference, effective as part of the 2021/2023 code update package).Ord. No. 2023-O-06
Code reference
Centennial is in Climate Zone 5B.
Code reference
The code applies to alterations, additions, and remodels per IECC Chapter 5 (existing buildings), with the prescriptive requirements of Chapter 4 (or equivalent U-factor/UA paths) generally applying to new or modified portions of the thermal envelope.
Code reference
Key prescriptive requirements relevant to remodels/additions (drawn from 2018 IECC Table R402.1.2 and related sections for CZ 5; these are the base code values with no local amendments identified that alter them):
Ceiling/attic insulation
Minimum R-49 (or equivalent U-factor ≤ 0.026).
Adopting reference
2018 IECC R402.1.2 (Table R402.1.2).
Wood-frame wall insulation
R-20 cavity or R-13 cavity + R-5 continuous insulation (or equivalent U-factor ≤ 0.060).
Ord. No. 2023-O-06Source: centennialco.gov

Codes are amended regularly — verify current requirements with City of Centennial — Building Division.

text

What plumbing work covers in the Denver metro

Plumbing projects in the Denver metro range from leak diagnosis and fixture replacement to water heater work, drain clearing, and full rough-in for remodels. Residential jobs often involve kitchens, baths, laundry rooms, and service line transitions. Commercial work may add restroom groups, grease or floor drains, and coordination with other building systems. A municipally licensed Denver general contractor coordinates the overall project and the licensed specialty trades required for the work. Scope should state whether the job is repair, fixture swap, water heater replacement, or a remodel rough-in that will be inspected.

text

Common residential and remodel scopes

Typical homeowner requests include repairing supply or drain leaks, replacing faucets and toilets, addressing slow drains, and planning plumbing changes during kitchen or bathroom remodels. Remodel plumbing usually means relocating or adding supply, drain, and vent lines so fixtures land correctly for the new layout. Before walls close, a clear plan covers fixture locations, shutoff access, venting strategy, and whether existing pipes will be reused or replaced. Cost is project-specific and depends on access, pipe type, fixture count, and whether structural or finish trades are also in the schedule.

text

Permits and who coordinates the work

Many plumbing alterations require permits and inspections through the local city or county building department. In Colorado, plumbing is regulated through DORA for the specialty trade. Cities and counties license general contractors. Colorado has no statewide general contractor license. Autotelic acts as a municipally licensed Denver general contractor and coordinates licensed specialty trades for these scopes. Permit responsibility and inspection sequencing should be stated in the project plan.

text

What to prepare before a site visit

Useful details include the property city, whether the issue is an active leak or a planned remodel, fixture types involved, water heater type and age if known, and any recent remodel drawings. Photos of the problem area and access to shutoff valves help define a practical first visit. For commercial sites, note restroom counts, business hours constraints, and whether work must be phased around occupancy.

FAQ

Common questions

What plumbing problems should be treated as urgent?

Active supply leaks, no water, sewage backups, and water heater failures that risk property damage should be addressed promptly. Shut off water at the fixture or main when safe to do so, then get a site assessment.

Who handles the plumbing permits and licensing?

A municipally licensed Denver general contractor coordinates the project and the licensed specialty trades required for the work. Local city or county building departments issue permits and inspections. Colorado has no statewide general contractor license. DORA regulates specialty trades such as plumbing.

Can plumbing be moved during a kitchen or bathroom remodel?

Often yes, but relocating supply, drain, and vent lines depends on framing, stack location, slab or crawlspace access, and code clearances. The remodel plan should show final fixture locations before rough-in.

How is commercial plumbing different from residential work?

Commercial projects more often involve multiple fixtures, accessibility requirements, specialized drains, and tighter coordination with occupancy and inspections. Phasing around open hours is common.

What information helps define an accurate plumbing scope?

City or county location, repair vs remodel intent, fixture list, leak history, water heater details if relevant, and photos or drawings of the work area. For remodels, a layout with proposed fixture locations is especially useful.

Service Area

Serving Centennial and Arapahoe County

We serve Centennial, CO and all surrounding Denver metro communities. Our team is based in Denver and operates throughout the Front Range, from Castle Rock to Longmont and everywhere in between. Contact us for a free estimate on your Centennial project.

How It Runs

01

Survey

02

Design

03

Build

04

Verify

DESIGN SERVICES

CONSTRUCTION

TECHNOLOGY

TRUSTED TO BUILD FOR

  • Punch Bowl SocialFirst four locations
  • Spectrum RetirementSenior living communities
  • Denver HighlandsFirst modular custom home

Free Estimate

Get a free plumbing estimate in Centennial

Tell us about your Centennial project — we respond fast, and estimates are always free.

Name, phone, and email required.

Verifying you're human…